Skip to content
3D PRINTING · TECHNOLOGY · INNOVATION3DPS EUROPE / SIGNAL PULSE
SUPPORT OUR INDEPENDENT PROJECTSKo-fi ↗4fund ↗
3DPS/ SIGNAL
SIGNAL / Software / AI

Support Fins: Breakaway Supports Baked Directly into the STL

An open-source browser tool adds breakaway “fins” to overhangs directly in the geometry, allowing the resulting model to be sliced with supports disabled.

Support Fins: Breakaway Supports Baked Directly into the STL

The support is not generated by the slicer

Support Fins takes a different approach from conventional slicer supports: the support geometry is baked directly into the STL or 3MF model. On printfins.com, users can load a model, inspect overhangs and place support fins against suitable faces.

Automatic assistance and manual placement

The browser tool provides overhang analysis, orientation assistance and manual fin placement. Users can adjust material and fin parameters, layer height and support gap.

What goes into the file?

According to the project description, exported STL/3MF files contain geometry only. The fins therefore become part of the model rather than depending on a particular slicer profile.

Video and source code

Video demonstration: YouTube – Support Fins.

The source code is available on GitHub.